The DELTA SA180
includes 1/3 HP,
1725 RPM, 120
Volts induction
motor and
controls, miter
gauge, 1" X 42"
100-grit belt,
8" diameter,
60-grit disc,
instruction
manual 8"
diameter disc
operates at 1725
RPM for
finishing hard
and soft woods,
plastics,
composites and
more.
Tilting
cast-iron tables
on belt and disc
units are
slotted for
miter gauge use.
Factory-set belt
tensioning and
one-knob belt
tracking for
accurate
operation.
Built-in, 1-1/2"
O.D. dust spout
for adaptation
to a dust
collection
system or shop
vacuum. The
narrow belt
width is ideal
for sanding
odd-shaped
pieces. Steel
platen is
removable to
facilitate
working with
curved pieces.
Belt cover is
removable for
access to the
idler wheel when
performing
contour sanding
operations.
Compound angles
can be achieved
on both units by
tilting the
table and
utilizing the
standard-equipment
miter gauge.
Miter gauge
turns and locks
for common
angles 45
degrees left and
right.
